Ok, I tried this out. Setup is a bit of a chore but not difficult, mostly making sure that the correct version of neovim (> 8) is installed. I have only one bit of feedback, but for some reason it's a deal-killer for me.
Vim is my go-to text editor and VS Code with vim emulation is my go-to IDE, so I was excited to try.
The vim emulator puts the `:` command in the status bar on the lower left, quite like vim itself does. Type `:w` and you see that in the status bar.
By contrast,the way that command `:` is handled in the embedded neovim extension is that a search window pops up at the top where the commands and files drop-downs are (same place that gets the cursor when hitting ctrl-p). This confused and dismayed me so much that I immediately noped out, disabled the extension and went back to using the emulator. It might also have been dismaying that `w` was not one of the listed commands, only `wq` which is not what I wanted. `w` did work, but I was done.
I probably could get used to it, but I'm inclined to jettison things that mess with what I'm used to unless there's a massive value-add. As for now, I pretty much only use vanilla vim and so the emulator is good enough. When I need more power, I open vim either in a separate terminal or sometimes right in the VS Code embedded terminal. I don't really have an intense need for real neovim in VS Code at this point.
Finally, I do want to give props to the creator! This is an amazing accomplishment, and I hope that my feedback is not discouraging! If there could be a setting to reflect the commands in the status bar as the vim emulator does, I will be eager to try it out again. But still, great job!
Vim is my go-to text editor and VS Code with vim emulation is my go-to IDE, so I was excited to try.
The vim emulator puts the `:` command in the status bar on the lower left, quite like vim itself does. Type `:w` and you see that in the status bar.
By contrast,the way that command `:` is handled in the embedded neovim extension is that a search window pops up at the top where the commands and files drop-downs are (same place that gets the cursor when hitting ctrl-p). This confused and dismayed me so much that I immediately noped out, disabled the extension and went back to using the emulator. It might also have been dismaying that `w` was not one of the listed commands, only `wq` which is not what I wanted. `w` did work, but I was done.
I probably could get used to it, but I'm inclined to jettison things that mess with what I'm used to unless there's a massive value-add. As for now, I pretty much only use vanilla vim and so the emulator is good enough. When I need more power, I open vim either in a separate terminal or sometimes right in the VS Code embedded terminal. I don't really have an intense need for real neovim in VS Code at this point.
Finally, I do want to give props to the creator! This is an amazing accomplishment, and I hope that my feedback is not discouraging! If there could be a setting to reflect the commands in the status bar as the vim emulator does, I will be eager to try it out again. But still, great job!